Instructions / Assembly

This hardhat has been shipped with the
suspension not installed to prevent distortion
during shipping. To install the suspension:
1. Set the hardhat upside-down on its crown.
2. Line up the suspension so that the sweatband is at
the front next to the brim (Figure 1).
3. Push each of the four clips into its slot (Figure 2).
You should feel and hear them snap into place.
4. Ensure that the pin-lock band ends are not
connected together.
5. Place helmet on head and push down on top of
helmet until comfortable wearing height is reached.
6. Adjust the pin-lock band while on head by inserting
the pins inside the holes at the desired position
(Figure 3) while having proper and comfortable fit.
SAFETY HARD HAT
USER INSTRUCTIONS
Figure
Brim
Sweatband
1
Figure
2
Clips
Standard orientation
Reverse orientation
Clips
Figure
3
PINLOCK INSTRUCTION SHEET