Installation Guide

1. 2. 3.
1. 2. 3.
5. 6. 7.
4.
Sensor
Exhaust Vents
1. Plug the “Control box” into a grounded 120VAC receptacle, then plug in the
microwave power cord into the “Control box”.
2. Attach the “magnetized Sensor” to the microwave unit just above or beside
the exhaust vent slots. The Sensor has a built-in magnetic mounting.
IMPORTANT:
Microwave oven vents have been designed & slanted to expel smoke in a
specific direction. It is important that the magnetized Sensor be positioned
above or besides these exhaust vents to ensure that the expelled smoke to
pass directly over/into the Sensor.
Refer to these sample images to correctly position the Sensor on the
microwave.
In some instances the microwave vents may be located underneath or at the back of the microwave (do not confuse the air-intake holes on the back as the exhaust
vents). Again the Sensor should be positioned so that the expelled smoke will pass directly over/into the sensor.
THE Safe-T-sensor ™ must be tested periodically to ensure proper operation and optimum performance.
Ensure that the red LED on the Sensor is lit, which indicates that it is receiving power.
Clean the Sensor module at least once a year for proper operation. Ensure the slots are free from any debris. The Sensor cover is removable for cleaning.
Steps to clean Safe-T-sensor™:
1. Unplug the microwave and Safe-T-
sensor™ from the power outlet.
2. Gently remove the Sensor cover from
the Sensor case. (Fig. 1 to 3)
3. Clean any dust or debris by using a
tissue. (Fig. 4 to 5)
4. Place the Sensor cover back on the Sensor case so
it clicks back into place. (Fig. 6 to 7)
5. Plug the microwave into Safe-Tsensor™ control box
then, plug the control box back into the power outlet.
6. Position the Sensor near the microwave’s exhaust vent.
7. For Sensor that is mounted underneath the microwave base, clean the Sensor as shown in Fig.4 above.
Warning! There are no serviceable parts inside
Safe-T-sensor™.
Do not open the Safe-T-sensor™ .
Safe-T-sensor™ should not be exposed to high
humidity (80%) and ambient conditions exceeding
30 degrees C(90 degrees F) or occasionally
exposed to water.
B. Back or Underneath Installation
Please ensure that microwave is
not sitting directly on top of the
Safe-T-sensor™ to prevent
possible damage.
Refer to Section: G “Care” for instructions on
how to clean Sensor.
1. LED on sensor lights up after connecting power indicating the Sensor is
monitoring the microwave and functioning properly.
2. DO NOT press the Test/Reset button.
3. If smoke is detected by the Sensor, it will interrupt power to the microwave
and the Sensor will beep for 5 seconds indicating that the cooking process
has been stopped. The power to the microwave will be restored automatically,
but cooking will not continue until attended to by the user.
4. Do not immediately open microwave when smoke is detected. Visually
check for fire, wait 5 minutes then remove contents with heat protective
gloves.
E. Installation:
F. Operation & Testing
1. Remove the Sensor cover.
2. Place the Sensor underneath the microwave base where the exhaust vent slots are located.
A. Side vent Installation:
G. Care