Instruction Manual

MENU
You can use the Input Settings menu to congure the speaker’s input
sensitivity control as well as the Delay and Phase control settings.
The MIC setting is for the Input 1 input sensitivity control. After selecting
the MIC input, the MIC light on the panel will turn on.
The Hl-Z setting is for the input 2 input sensitivity control. After selecting
the Hl-Z input, the Hl-Z light on the panel will turn on.
The Delay menu is for creating time calibrations with other speakers.
The options available range between 0 and 69.19 feet. The delay can be
changed in increments of 0.69 feet. The default setting is 0 feet.
Phase setting preset for the entire loudspeaker system.
The Factory Presets menu is for conguring the type of sound the
speaker sends. The options are: LIVE, MUSIC, SPEECH, and MONITOR.
You can use the MASTER VOL menu button to congure the presets for
different situations.
• LIVE – for live sound applications (default).
• MUSIC – for recording music and playing dance music.
• SPEECH – for voice-only applications.
• MONITOR – for ground monitoring.
The Sub Setting menu is for selecting the high-pass frequency or
matching subwoofer when one is used in the speaker setup. The options
available for this selection are: No Sub, 80 Hz (80 Hz), 100 Hz (100 Hz),
120 Hz (120 Hz), 150 Hz (150 Hz), and the Qualcomm is a 24 dB/octave
Linkwitz/Riley crossover. The 80 Hz (100 Hz), 100 Hz (100 Hz), 120 Hz
(120 Hz), and 150 Hz (150 Hz) options are general high-pass settings
for use with other subwoofers. The settings are optimized for the woofer
(including delays for optimal overlay).
The default is No Sub.
EQ menu
The EQ menu is a 4-band EQ (equalizer) that you can ne tune in
addition to FUNCTION and LOCATION. The options available are: HI,
MD, LM, and LO.
Back
HI 12.1K Default: 0 decibels
MD 2.52K Range: -18 decibels – +18 decibels
LM 500.0 ALLBYPASS will be deleted, invalidating all set EQs.
LO 101.5 FLAT is to restore all adjusted EQs to factory settings.
NOTE
The indoor equalizer (EQ) range shown is the factory default range for
individual speakers. When the woofer is selected, any EQ below the
crossover point is bypassed.
To use EQ above the crossover point, do the following.
> Rotate the MASTER VOL knob to reach the desired frequency.
User Programs (saved user settings)
There are 16 presets that you can change and save EQ values for. You
can also give them custom names with 7 English letters/symbols. Use
the load/save/delete options to do this.
System menu
The System menu is for conguring the system. You can also congure
the accessibility of this menu and modify the settings, and reset to factory
defaults.
The FIRMWARE/HARDWARE menu displays the current preset and
rmware version.
XPRS122
The Name menu shows the name of the current speaker. This menu
enables you to customize the name of the speaker.
The Default Settings menu is for resetting the speakers to their original
factory settings. The options for this selection are: NO or YES.
The Exit menu is for returning to the main menu.
To reset your system to the original factory settings, follow the steps
below.
1. From the System menu in the DSP menu, select Default Settings.
XPRS122
A message prompt to restore the factory settings will appear.