Instruction Manual

Rear panel
(subwoofer model)
12
3
4
5
a
8
9
6
7
1
AC INPUT
The AC connection is established via the IEC connector. The IEC
connector is compatible with a lockout power cord (not included).
2
POWER
AC switch for turning the power on or off. When POWER is turned on,
the LED lights up.
3
LINK
The XLR output sends mixed input signals to other speakers or
subwoofers. VOLUME (input level) controls the level of signal sent to
LINK. The MASTER VOL and DSP control settings do not affect the
LINK signal.
4
INPUT LEFT (mono)/RIGHT
5
POWER indicators
The POWER LED lights up when the speaker is turned on.
6
SIG/LIMITER signal light
Lights up green when there is a signal, and red when the amplifier
starts to compress.
7
3DSP PRESET MODES
BOOST/EXTENDED LF/NORMAL
8
LPF
80 Hz/100 Hz/120 Hz
9
POLARITY
REVERSE/NORMAL
a
VOLUME
Level control of an input signal.
DSP control
With the integrated DSP control menu, you can choose from multiple
DSP and system settings on the speaker.
To access the DSP control menu, follow the steps below.
1. Press the MASTER VOL knob and the DSP control menu will
appear.
2. Use the MASTER VOL knob to scroll through the menu items.
3. Press the MASTER VOL knob to select the menu item you want to
modify.
The menu item you chose will open on the right side of the DSP menu.
4. Use the MASTER VOL knob to scroll through the menu items.
5. Press the MASTER VOL knob to select a setting.
The setting will be saved and you will return to the level above in the
menu.
XPRS122
6. Repeat steps 2 through 5 to modify other DSP and system settings.
7. Select EXIT to return to the main screen.
Full-range speaker DSP control menu
Full-range speaker DSP control menus are included on the XPRS102
and XPRS122 units.
EXIT menu item
Use the EXIT menu item to return to the home screen.
NOTE
After a minute of menu inactivity, the display turns off but the speaker
continues working as normal.