Operation Manual

4 Switching On
18
6 To skip back or forward to another track,
press (but don't hold) $ or ›.
Pressing › once skips to the start of the next track on the disc. Further
presses take you to subsequent tracks.
Pressing $ once takes you to the beginning of the current track. Further
presses skip to the start of previous tracks.
You can use the track skip buttons while the disc is paused, too. The track
number changes while the disc remains paused.
7 To stop playback, press & .
If the disc was paused, then the pause mode is cancelled.
On the previous page, you may have adjusted the volume while the CD was playing.
Volume is adjustable from zero (silence) to 36 (maximum volume) using the volume
UP and DOWN buttons on the remote.
So that you can adjust the sound to your liking, you can also adjust the bass, treble,
balance and subwoofer level. Start a disc playing before working through the steps
below so that you can hear the effect of changes as you make them.
Adjusting the Sound
1 Press SOUND.
Press repeatedly to switch between:
BASS - TREBLE - BALANCE - WOOFER LEVEL
Stop on the one you want to adjust.
2 Press SET.
The display shows the current level.
3 Use the $ and › buttons to adjust the
level.
The display indicates the level as you change it. (The subwoofer has just three
settings: LOW, MEDIUM and HIGH.)
4 When you're happy with the level, press
SET again.
Tip
In step 3, if more than
5 seconds goes by
without you pressing a
button, the system as-
sumes you're happy
with the new level and
sets it for you, without
you having to press
SET (step 4).
AUX/CD-R SOUND DISPLAY SET MD TAPE TIMER/
CHARACTER
&
CANCEL
REC
$
! —
›
+ ⁄
VOL
STANDBY/ ON
SET
SOUND
4
¢
Display shows the current level
New level after adjusting
Choose BASS to control the low
frequency sounds