Operation Manual

103
Chapter 8 Customising the Audio Source SettingAV
➲ Compensating for equaliser curves (EQ-EX)
➞ Page 104
1 Touch “BASS” or “TREBLE” in the
AUDIO menu.
2 Touch  or  to select the desired fre-
quency.
3 Touch “+” or “–” to adjust the bass or tre-
ble level.
Each time you touch “+” or “–” increases or
decreases the bass or treble level. +6 to –6 is
displayed as the level is increased or
decreased.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Touch “LOUDNESS” in the AUDIO menu.
2 Touch “ON” to turn loudness on.
To turn loudness off, touch “OFF”.
3 Touch  or  to select a desired level.
Each time you touch  or  selects level in
the following order:
LOW — MID — HIGH
Using subwoofer output
This navigation system is equipped with a sub-
woofer output which can be turned on or off.
❒ When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level, and the phase of the subwoofer.
1 Touch “SUB WOOFER” in the AUDIO
menu.
When PREOUT (the subwoofer controller
setting in INITIAL menu) is FULL, you can-
not select “SUB WOOFER”.
➲ Setting the rear output and subwoofer con-
troller ➞ Page 107
2 Touch “ON” to turn subwoofer output on.
To turn subwoofer output off, touch “OFF”.
3 Touch “REVERSE” or “NORMAL” to
select the phase of subwoofer output.
4 Touch “+” or “–” to adjust the output
level of the subwoofer.
+6 to –6 is displayed as the level is increased
or decreased.
5 Touch  or  to select cut-off frequency.
Each time you touch  or  selects cut-off fre-
quencies in the following order:
50 — 80 — 125 (Hz)
Only frequencies lower than those in the
selected range are output from the subwoofer.
Audio Adjustments