Troubleshooting Guide

Table Of Contents
3.2 Electrical Components Disassembly
WARNING: Antistatic gloves must be worn when you disassemble the electronic box.
Note: Remove the air outlet grille (refer to 3.1 Panel Plate Disassembly) prior to disassembling electrical parts.
Outdoor Unit Disassembly 16
Note: This section is for reference only. Actual unit appearance may vary.
Procedure Illustration
1) Disconnect the connector for
compressor and release the ground
wire (1 screw, for some models )
See Fig. 1).
2) Remove the electronic control
box subassembly (see Fig. 2)..
Note: Electric control box cover
cannot be removed.
Figure 1
Figure 2
3.2.1. Electronic Control Box Subassembly Removal (EW-1, EW-2)
Scope of Models Covered:
YN009GMFI22RPE / YN009GMFI20RPD / YN012GMFI22RPE / YN012GMFI20RPD / YN018GMFI20RPD
YN009AMFI22RPE / YN009AMFI20RPD / YN012AMFI22RPE / YN012AMFI20RPD