Troubleshooting Guide

Table Of Contents
2.2. Electrical Parts Disassembly (Antistatic gloves must be worn.)
Note: Remove the front panel (refer to 2.1. Front Panel Disassembly) prior to disassembling electrical parts.
Procedure Illustration
1) Cut the ribbon with a cutter, then pull
out the coil temperature sensor (T2)
(see Fig. 14).
2) Remove one fastening screw of the
electronic control box and two screws
used for the ground connection (see
Fig. 14).
3) An upward force is maintained until
the cover of electronic control box is
removed (see Fig. 15).
Figure 14
Figure 15
Note: This section is for reference only. Actual unit appearance may vary.
Ribbon
T2 Sensor
Ground Screws
Indoor Unit Disassembly 9