Troubleshooting Guide

Table Of Contents
4. Information Inquiry
To enter information inquiry status, complete the following procedure within ten seconds:
1. Press LED(or DO NOT DISTURB) 3 times.
2. Press SWING(or AIR DIRECTION) 3 times.
Finish 1 and 2 within 10 seconds, you will hear beeps for two seconds, which means the unit goes into
parameter checking mode.
Use the LED(or DO NOT DISTURB) and SWING(or AIR DIRECTION) buttons to cycle through information displayed.
Pressing LED(or DO NOT DISTURB) will display the next code in the sequence. Pressing SWING(or AIR
DIRECTION) will show the previous.
The following table (p. 10) shows information codes. The screen will display this code for two seconds, then the
information for 25 seconds.
Troubleshooting 9