Instruction Manual
96
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Playing Back (ZONE 3)
At the time of purchase, the remote controller is in the mode to control playback
in the main room. Settings are required to playback a source in ZONE 3.
Set "Speaker" - "Conguration" - "Zone Speaker" in the System Setup menu
( p96) to "Zone 2/Zone 3".
1. Point the remote controller at the unit, and while pressing and holding the
ZONE 3 SHIFT button on the remote controller, press .
• "Z3" on the display of the main unit lights up.
2. While pressing and holding the ZONE 3 SHIFT button on the remote controller,
press the input selector of the input source you want to play in the separate
room. When operating on the main unit, press the ZONE CONTROL button
repeatedly to select "Z3" on the display, then within 8 seconds select the input
you want to play in another room using the input selector dial.
3. To adjust the volume of the ZONE speakers in the separate room, press
the volume buttons while pressing the ZONE 3 SHIFT button on the remote
controller. When operating on the main unit, press the ZONE CONTROL
button repeatedly to select "Z3" on the display, then within 8 seconds adjust
using the MASTER VOLUME knob.
• If you turn the unit to standby during multi-zone playback, the Z3 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 3 to on while the unit is in standby also switches the
playback mode to playback in a separate room only.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD audio signals cannot be output to ZONE 3 when selected with the "NET"
or "USB" input selector.
• If ZONE 3 is on, power consumption during standby will increase.
To set the function to o: While pressing and holding ZONE 3 SHIFT button,
press . Alternatively, press the ZONE 3 ON/OFF button on the main unit.