Instruction Manual
14
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Front Panel≫ Rear Panel≫ Remote≫
1. DIGITAL AUDIO IN OPTICAL/COAXIAL jacks: Input TV or AV component
digital audio signals with a digital optical cable or digital coaxial cable.
2. ANTENNA AM LOOP/FM UNBAL 75 Ω terminal: The supplied antennas are
connected.
3. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH
enabled device. Adjust their angles according to the connection status.
4. HDMI OUT jacks: Transmit video signals and audio signals with an HDMI
cable connected to a monitor such as a TV or projector.
5. RS-232C port: Connect a home control system equipped with an RS-232C
port. For adopting a home control system, contact the specialized stores.
6. HDMI IN jacks: Transmit video signals and audio signals with a HDMI cable
connected to an AV component.
7. NETWORK port: Connect to the network with a LAN cable.
8. USB port: A USB storage device is connected so that music les stored in it
can be played. ( p75) You can also supply power (5 V/1A) to USB devices
with a USB cable.
9. AC IN: The supplied power cord is connected.
10.
SIGNAL GND terminal: The ground wire of the turntable is connected.
11.
AUDIO IN jacks: Input AV component audio signal with an analog audio cable.
12.
IR IN/OUT port: Connect a remote control receiver unit. ( p62)
13.
12V TRIGGER OUT A/B jack: Connect a device equipped with a 12V trigger
input jack to enable power link operation between the device and this unit.
( p63)
14.
SPEAKERS terminals: Connect speakers with speaker cables. (North
American models support banana plugs. Use a plug 4 mm in diameter. Y plug
connection is not supported.)
15.
SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a
subwoofer cable. Up to two powered subwoofers can be connected. The same
signal is output from each of the SUBWOOFER PRE OUT jacks.
16.
ZONE 2 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplier or a power amplier in a separate
room (ZONE 2).
ZONE B LINE OUT jacks: Connect to a pre-main amplier with an analog
audio cable, and simultaneously output audio of the same source as that of
the speakers (ZONE A) connected to this unit.