Instruction Manual

128
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Zone 2 Preout Zone 2 Set the output destination of the audio that is output
from the ZONE 2 PRE/LINE OUT or ZONE B LINE
OUT terminals.
"Zone 2": When connecting a pre-main amplier in
a separate room (ZONE 2)
"Zone B": When connecting a pre-main amplier,
transmitter of wireless headphones, etc. to ZONE B
• This setting is xed to "Zone 2" when "Zone
Speaker" is set to "Zone 2" or "Zone 2/Zone 3".
Bi-Amp No Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
• This setting will be set to "No" in either of
following cases.
– When 2 sets of height speakers are used
– When "Zone Speaker" is set to "Zone 2" or
"Zone 2/Zone 3"
Speaker
Impedance
6 ohms or above Set the impedance (Ω) of the connected speakers.
"4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6 ohms or above": When the connected speakers
all have 6 Ω or more impedance
• For impedance, check the indications on the
back of the speakers or their instruction manual.
 Crossover
Change the settings of crossover frequencies.
Setting Item Default Value Setting Details
Front Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with su󰀩cient low
range capabilities
• If "Conguration" - "Subwoofer" is set to "No",
"Front" will be xed to "Large" and the low
pitched range of the other channels will be output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Center Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with su󰀩cient low
range capabilities
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Conguration" - "Speaker Channels" matches
the number of connected channels.
Height 1 Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with su󰀩cient low
range capabilities
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Conguration" - "Speaker Channels" matches
the number of connected channels.