Operation Manual

62
Remote Control of Other Components
DVD/DVR Player Controls
This remote control can control this component after entering the proper codes or teaching the re-
ceiver the commands (see p.55-57).
1 SOURCE
Press to switch the DVD/LD player between
STANDBY and ON.
2 4
Press to return to the start of the current chapter
(track). Repeated presses skips to the start of
previous tracks. When controlling a DVR, use this
button to go back channels (channel +).
3 ¢
Press to advance to the start of the next chapter
(track). Repeated presses skips to the start of
following tracks. When controlling a DVR, use this
button to go forward channels (channel +).
4 8
Press to pause playback (on some models this will
freeze-frame the picture).
5 Number buttons
Use the number buttons to navigate the on-screen
display.
The ENTER button is used as a SETUP button for
the DVD players internal menus. The +10 button is
used to select tracks higher than 10.
6 ¡
Hold down for fast forward playback.
Use MULTI CONTROL buttons to put the remote control in the stated
mode.
memo
Î
SOURCE
TV VOL
TV
TVFUNK
ENTER
TUNE
TUNE
D.ACCESS BAND
GUIDE MENU
RDM
CLASS
RETURN
MIDNIGHT DSP STEREO FUNCTION
ADVANCED STANDARD MUTE
S.MODE CLEAR DTV INFO
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/ DTS
RECEIVER DIRECT CONTROL
MPX DTV ON / OFF DTV MENU
ST ST
CHANNEL
RECEIVER
TV CONTROL
MASTER VOLUME
MULTI CONTROL
DVD
CD CD-R TUN TVC
RECEIVER
 ! ⁄
*‹&
2
TV
VCR
1
VCR
2
4 ¢
¶
ENTER
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
EFFECT/CH SEL
DISC
+10
VIDEO SELECT MULTI CH INPUT
1 2 3
4 5 6
7 8 9
0
=
@
#
4
0
3
~
-
5
1
8
!
2
9
6
%
$
7
7 1
Hold down for fast reverse playback.
8 3
Press to start playback (on some models, pressing
this when the disc tray is empty will cause the disc
tray to open).
9 7
Press to stop playback (on some models, pressing
this when the disc is already stopped will cause
the disc tray to open).
0 MENU
Displays menus concerning the current DVD or
DVR you are using.
- USE THESE BUTTONS TO NAVIGATE
DVD MENUS
5 :
up
∞ : down
ENTER: enter the command selected
2 : left
3 : right
= ¶ MPX Button
Use to start recording. To prevent accidental
recording, this button must be pressed twice to
take effect (the second press must be within 10
seconds of the first).
~ ENTER
Use to display the lead trailer on a DVD.
! TOP MENU
Press to call up the menu programmed on the
DVD.
@ RETURN
Press to return to the beginning of the current
chapter (track). Press repeatedly to return to the
beginning of previous chapters (tracks).
# S.MODE
Use to select the screen mode.
$ CLEAR
This button clears the on-screen display (OSD) for
the DVD menu.