Operation Manual

59
Remote Control of Other Components
OPERATION
Clearing All the Remote Control Settings
Clears all presents, all learned functions and restores the factory presets.
SOURCE
ENTER
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
DISC
+10
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
1 2 3
4 5 6
7 8 9
0
TV
VCR
1
VCR
2
4
4
2
1
4
3
Checking Preset Codes
Use this process to check which preset code is associated with a Multi Control button:
1 Press RECEIVER.
2 Press REMOTE SETUP and hold for three
seconds.
The LED on the remote will blink twice.
3 Press the MULTI CONTROL button you want
to check the preset code for.
4 Press 9, 9 then 0.
Each preset code consists of four digits, for example 1329. Each
digit will be represented by a series of blinks on the remote’s
LED—3 blinks to represent the digit “3”, etc.
5 Press 1.
The blinking LED indicates the left-most digit of the preset code
(“1” in the example above).
6 Press 2.
The blinking LED indicates the next digit of the preset code (“3” in
the example above).
7 Press 3.
The blinking LED indicates the next digit of the preset code (“2” in
the example above).
8 Press 4.
The blinking LED indicates the right-most digit of the preset code
(“9” in the example above).
Î
SOURCE
ENTER
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
D.ACCESS BAND
GUIDE MENU
CLASS
RETURN
MIDNIGHT DSP STEREO FUNCTION
ADVANCED STANDARD MUTE
S.MODE CLEAR DTV INFO
RDM
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/ DTS
RECEIVER DIRECT CONTROL
MPX DTV ON / OFF DTV MENU
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
DISC
+10
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
1 2 3
4 5 6
7 8 9
 ! ⁄
0
*‹&
2
TV
VCR
1
VCR
2
4 ¢
¶
ENTER
TUNE
TUNE
ST ST
4
2
3
4
1
5-8
1 Press RECEIVER.
2 Press REMOTE SETUP and hold for three
seconds.
The LED on the remote will blink twice.
3 Press the MULTI CONTROL button .
4 Press 9, 8, then 1.
The LED blinks in sets of two twice (thus four times) to indicate the
button has been cleared.