Operation Manual

56
Remote Control of Other Components
Learning mode: Programming signals from other remote controls
If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this function to program in signals from the remote control(s) of your other component(s). This
operation can also be used after recalling a preset code to program additional operations not covered in the
preset codes.
1 Press RECEIVER to turn the power on.
The STANDBY indicator goes out.
2 Press RECEIVER.
This switches the remote to the receiver control mode.
3 Press the REMOTE SETUP button and hold
for three seconds.
The LED will blink twice.
4 Press the MULTI CONTROL button for the
component you want to control and then
press 9, 7, then 5 to select the LEARNING
setup mode. The remote is ready to learn
new commands from other remote controls.
The LED will blink twice.
To cancel LEARNING setup mode
Press REMOTE SETUP button.
After ten seconds if no commands are entered the remote will
revert to its previous mode.
5 Press the button to be programmed (for
example the 3 [play] button).
The LED flashes rapidly.
Î
SOURCE
ENTER
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
D.ACCESS BAND
GUIDE MENU
RDM
CLASS
RETURN
MIDNIGHT DSP STEREO FUNCTION
ADVANCED STANDARD MUTE
S.MODE CLEAR DTV INFO
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/ DTS
RECEIVER DIRECT CONTROL
MPX DTV ON / OFF DTV MENU
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
DISC
+10
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
1 2 3
4 5 6
7 8 9
 ! ⁄
0
*‹&
2
TV
VCR
1
VCR
2
4 ¢
¶
ENTER
TUNE
TUNE
ST ST
3,4
4
2
1
4
4