Operation Manual

55
Remote Control of Other Components
OPERATION
1 Press RECEIVER to turn the power on.
The STANDBY indicator goes out.
2 Press RECEIVER.
This switches the remote to the receiver control mode.
3 Press the REMOTE SETUP button and hold
for three seconds to select the preset
mode.
The LED will blink twice.
4 Press the MULTI CONTROL button for the
component you want to control.
Each button can be set to control one of the following
components.
: DVD/LD player or DVD Recorder, VCR
: TV , Satellite tuner or Cable TV tuner
: CD player, CD-R, TAPE, MD, DAT
: FM/ AM tuner
5 Use the number buttons to enter the 4 digit
setup code.
The LED will blink after each digit is input and will blink twice
to confirm a valid code has been input.
If the LED shows one long blink it means an invalid code has
been input. Check the preset code list and try again. If you are
not able to input a preset code you can refer to page 58 to
teach the remote control individual commands.
Repeat steps 2 through 5 to assign preset codes for as
many components as necessary.
• The Receiver button cannot be preset.
• You can only input a code for the component type
written on each MULTI CONTROL button. See page 58
for information on how to program a different type of
component than specified on the button.
• If you recall a preset code for the tuner (TUN MULTI
CONTROL), you will not be able to control the built-in
tuner of this receiver using the remote. To reset the
remote to the built-in tuner, input the preset code 0080.
CD
CD-R
DVD
TUN
TV
TVC
VCR
1
VCR
2
Î
SOURCE
ENTER
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
D.ACCESS BAND
GUIDE MENU
CLASS
RETURN
MIDNIGHT DSP STEREO FUNCTION
ADVANCED STANDARD MUTE
S.MODE CLEAR DTV INFO
RDM
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/ DTS
RECEIVER DIRECT CONTROL
MPX DTV ON / OFF DTV MENU
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
DISC
+10
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
123
456
789
!⁄
0
*‹&
2
TV
VCR
1
VCR
2
4¢
¶
ENTER
TUNE
TUNE
ST ST
3
2
1
5
4
Setting Up the Remote Control
In addition to controlling the receiver, the supplied remote control can operate your other components (DVD,
MD, VCR, TV, LD, CD, etc.). If your component(s) are listed in the “Preset Code List”, simply recall the
corresponding preset code.
Recalling preset codes
The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset
code is assigned, pressing the button will automatically set the remote to operate the respective component.
• Refer to “Preset Code List” on pages 72-76 for the components and manufacturers
available.
• Refer on p. 60–64 for detailed explanations on how to operate your other components.
memo
memo