Operation Manual
43
OPERATION
Basic Playback
Playing Stereo Sources
The following instructions show you how to use the receiver for stereo audio or audio-visual.
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
Be sure that the standby indicator turns off on the front
panel.
3 Press the MULTI CONTROL buttons or the
FUNCTION button to select the source you
want to playback.
The FUNCTION button cycles through the sources in the
following order:
4 Press the STEREO/DIRECT button to select
the stereo mode.
The STEREO indicator lights on the display.
5 Press RECEIVER.
This switches the remote to the receiver control mode.
6 Press the SIGNAL SELECT button to select
the input signal. Set to AUTO.
(See “Switching Analog and Digital Signal Input” on page 44
for more information.)
7 Start playback of the component you
selected in step 1.
8 Adjust the volume by using the VOLUME
buttons on the remote control or the
MASTER VOLUME on the front panel.
TUNER
CD-R/TAPE1
VCR 2
VCR 1/DVR
TV/SAT
DVD/LD
VIDEO
CD
Î
SOURCE
ENTER
LOUDNESS
INPUT ATT DIGITAL NR FL DIMMER
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
TV VOL
TV
TVFUNK
ENTER
TUNE
TUNE
D.ACCESS BAND
GUIDE MENU
RDM
CLASS
RETURN
MIDNIGHT DSP STEREO
FUNCTION
ADVANCED STANDARD MUTE
S.MODE CLEAR DTV INFO
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/ DTS
RECEIVER DIRECT CONTROL
MPX DTV ON / OFF DTV MENU
ST ST
CHANNEL
EFFECT/CH SEL
RECEIVER
TV CONTROL
MASTER VOLUME
DISC
+10
VIDEO SELECT
MULTI CONTROL
MULTI CH INPUT
DVD
CD CD-R TUN TVC
RECEIVER
1 2 3
4 5 6
7 8 9
! ⁄
0
*‹&
2
TV
VCR
1
VCR
2
4 ¢
¶
2
6
3
5
3
4
8
VSX-D709S
2
38
4
6