Operation Manual
26
Display
All the display information is explained and/or referenced here.
6 STEREO indicator
Lights when a STEREO mode is selected.
7 Source indicators
3 indicator lights the selected source.
8
TAPE 2 indicator
Lights when the TAPE 2 monitor is on.
9
MASTER VOLUME indicator
Displays current volume level.
10
Sound control indicators
DNR – Lights when the digital NR is on.
LOUDNESS – Lights when the Loudness is on.
TONE – Lights when the Tone control is on.
MIDNIGHT – Lights when the Midnight mode
is on.
11
Tuner indicators
STEREO – Lights when a FM stereo broadcast
is received in the auto stereo mode.
TUNED – Lights when a broadcast is received.
MONO – Lights when the tuner is set to
receive FM broadcasts with the mono mode
selected.
12
H.P (headphones)
Lights when headphones are connected to the
PHONES jack (speakers systems A and B both
turn off automatically).
13
Character display
Shows current mode, status, etc.
14
Analog level indicators
OVER – When the source signal is analog, this
lights if the signal is in danger of distorting.
Press INPUT ATT to lower the signal level.
ATT – Lights when ATT is used to reduce the
level of the analog source signal.
1 Speaker indicators
Light to indicate the current speaker system, A
and/or B.
2 SIGNAL SELECT indicators
Light to indicate the input signal you selected.
AUTO : Lights when the receiver is set to select
the input signal automatically.
ANALOG : Lights when analog signals are
assigned.
DIGITAL : Lights when digital audio signals are
selected.
3
Program Format indicator
2DIGITAL : Lights when a source with Dolby
Digital signals is played.
DTS : Lights when a source with DTS audio
signals is played.
For Dolby Digital or DTS sources, these
indicators change according to which channels
are active in the source.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel (mono).
RS – Right surround channel.
LFE – Low Frequency Effects channel.
4 2/dts mode indicators
2 DIGITAL – Indicates multi channel playback
of a Dolby Digital source.
2 PRO LOGIC – Lights when Dolby Pro Logic
decoding is switched on.
dts : When the 2/dts mode on the receiver is
on, this indicator lights to indicate playback of a
DTS signal.
5 DSP indicator (See p.40–41)
Light when a DSP or Advanced Theater mode
is selected.
Displays & Controls
12 3 4 56 7 8
91011121314