Manual

SURROUND EDIT OPERATION (GUI OPERATION) S C Intelfigent

System Control

* If you press the SURR EDIT button on a function operation

display, display switches to "SURROUND EDIT" indications

for the currently selected surround mode. (Press the EXIT

button to return to the original function operation display.)

• On the SURROUND EDIT display, you can adjust levels,

switch to the center mode, and adjust delay time.

(When using DOLBY PRO-LOGIC)

[ SETTING THE DELAY TIME J

When using DOLBY PRO-LOGIC SURROUND or SIMULATED

SURROUND, you can set the delay time between 16 ms and

30 ms (2 ms step).

The standard setting is 20ms, but you can select any setting

of your choice.

[ LEVEL ADJUSTMENT J

Example:When using DOLBY PRO-LOGIC

1. Press the CENTER MODE button to select the Center

Mode. (Refer to page 6 ) "1

NORMAL -_- WIDE _ PHANTOM

2. Press the TEST TONE button to switch the test tone

on.

The test tone is output from each of the speakers in the

following order. *2

---*Front Left -----* Center

Surround(Rear)-.-----Front Right _

3. Adjust so that the volume level isthe same from each

of the speakers.

• Use the CENTER LEVEL Jr-, -- buttons to adjust the

center speaker volume level. *3

• Use the REAR LEVEL 4-, -- buttons to adjust the rear

speakers volume level. *4

4. Press the TEST TONE button to switch the test tone

OFF.

NOTE:

"1 You can select the CENTERMODE when using DOLBY PRO-

LOGIC SURROUND, PRO-LOGIC THEATERand DOLBY 3CH

LOGIC.

When using DOLBY 3CH LOGIC, you can switch between

NORMAL and WIDEsettings.

*2 Whenthe CENTERMODE button is PHANTOMposition, no test

tone is output from the center speaker.

*3 Only when using DOLBYPRO-LOGICSURROUNDand DOLBY

3CH LOGIC can you adjust the CENTERLEVEL.

*4 When using DOLBY 3CH LOGIC, the REAR speakers are not

used.