Manual

CONNECTIONS

f IR Repeater connection 1

Connecting a supplied IR Repeater lets you also control other components with this unit's remote control.

NOTE:

To operate components not made by Pioneer, perform REMOTESET UP (P.34)after connecting an IR Repeater.

Remote control signals directed towards this unit or GUI operation signals are transmitted from the repeater as infrared signals,

enabling control of other components.

There are two kinds of infrared repeaters. Connect either or both to match the remote control requirements of different components.

MAIN-REPEATER

Use this to operate other components with this unit's remote

control or to operate using GUI on-screen indications.

Install on top of this unit as shown in the figure.

MAIN-REPEATER

[ ooo.ooo; \

]d) Insert the REPEATER's two

pegs into the holes on the

top.

(_) Install the REPEATER laying

on its side on the top.

MINI-REPEATER

Use this when a component operates incorrectly after receiving

a signal from this unit's remote control, or when it is difficult

for a component to receive signals from the Main-Repeater.

Stick it directly on the remote control sensor window.

There are two MINI-REPEATER terminals.

If you need another Mini-Repeater, contact you nearest Pioneer

Service Center.

MINI-REPEATER

D::........:oO_O __ _

VSX-D704S

pegs are usually

inserted in the two

rear holes.

Use the two front holes

when there's another

component on top of this

preventing easy reception

of the MAIN REPEATER's

infrared signals.

NOTE:

Toprevent possible damage, be careful to avoid accidentally

connecting the MINI-REPEATER to the MAIN-REPEATER

terminals.

VCR

(_ Remove the seal.

(_) Stick onto the remote control

sensor window.