Manual

3 Press A or V repeatedly to display the name of the

component's manufacturer.

! $

("VCR" is displayed onVSX-D508) _

. At J J - F_U_; F_ ILr_ -8=.

A list of all available preset codes is provided on page 56.

Point the remote toward the component to be controlled,

enter the 3 digit setup code.

When you enter the setup code, the remote emits a power ON/OFF

signal. If the component turns ON or OFF, you have entered the proper

code.

If the component does not turn ON or OFF and there is more than one

setup code, press <l<_or DD to select another code in step 3 or try

inputting another code (starting again from step 2).

Some manufacturers use several sets of remote control signals and the

first code may not correspond to your component.

........;;L! ;;LI

_.,._ _._ T_I_H_'_F_

L.IJH

Repeat steps 2 through 4 to assign preset codes for as many

components as necessary.

5 Press COMMANDER SET UP to exit the preset mode.

The remote control returns to the previous operation mode.

When operating a PIONEER'S DVD/LD player, set the

manufacturer code to "OOO" in the preset mode.

All codes enrolled in the manufacturer code list can be set

even if a code is not displayed.

• RECEIVER cannot be preset.

I Clearing the Remote Control Settings I

COMMANDER

SET UP

Clears all presets and restores factory installed presets.

Press the COMMANDER SET UP and 0 at the same time for

more 3 seconds.

• All the multi-control buttons on the remote control blinks, After

blinking three times, all the settings are canceled.