User manual

1111
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
Audio Adjust
Make advanced settings such as those related to multiplex audio or those related to the
volume of this unit.
Dual Mono/Mono
Setting Item Default Value Setting Details
Dual Mono Main Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be output
at the same time.
If multiplex audio is being played, "11" will be
displayed when
on the remote controller is
pressed.
Mono
Input Channel
Left+Right Set the input channel to use for playing any 2 ch
digital source such as Dolby Digital, or 2 ch analog/
PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Dolby
Setting Item Default Value Setting Details
Loudness
Management
On When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume
of dialog at a certain level. Note that when this
setting is Off, the DRC function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": Use this function
"Off": Do not use this function
Volume
Setting Item Default Value Setting Details
Mute Level −󲍤 dB Set the volume lowered from the listening volume
when muting is on. Select a value from "−󲍤 dB",
"40 dB", and "20 dB".
Volume Limit Off Set the maximum value to avoid too high volume.
Select "Off" or a value between "32 dB" and "
17 dB".
Power On Level Last Set the volume level of when the power is turned
on. Select a value from "Last" (volume before
entering standby mode), "−󲍤 dB", and "81.5 dB"
to "18.0 dB".
You cannot set a higher value than that of
"Volume Limit".
Headphone Level 0.0 dB Adjust the output level of the headphones. Select a
value between "12.0 dB" and "12.0 dB".