Manual
BEFORE OPERATING, ADJUST THE POSITION OF THESE SWITCHES
I TWO VOLTAGE SELECTOR SWITCHES ]
Only multi-voltage models are provided with these switches.
U,S. models are not provided with these switches.
Main voltages in Saudi Arabia are 127 V and 220 V only. Never
use this model with 110 V setting in Saudi Arabia.
The line voltage selector switches are on the rear panel. Before your
model is shipped from the factory, these switches are set to the
power requirements of the destination. Check that they are set
properly before plugging the power cord into the household wall
socket. If the voltage is not properly set or if you move to an area
where the voltage requirements differ, adjust the selector switches
as follows.
1. Use a medium-size screwdriver.
2. First, insert a screwdriver in the groove of the voltage selector at
the right, and adjust so that the tip of the groove points to the
voltage value of your area.
3. Next, insert a screwdriver in the groove of the voltage selector at
the left and adjust until the voltage is the same as at the right.
CHANNEL STEP SWITCH
(Not available on U.S. model)
The unit has been factory-preset to the channel allocation and de-
emphasis value for the area in which it is to be sold. If these values
are set incorrectly, the frequency display may stop at the wrong
frequency, or sound may be distorted, resulting in an inability to
reproduce reception signals at their proper sound quality. For this
reason, be sure to confirm that the values are set correctly before
using the unit.
[FM 100 kHz/AM 10 kHz] position:
Set to this position for areas with an FM reception step of 100 kHz and
AM 10 kHz.
[FM 50 kHz/AM 9 kHz] position:
Set to this position, for areas with an FM reception step of 50 kHz and
AM 9 kHz.
NOTE:
When unsure about the channel allocation and de-emphasis values
of your area, consult your dea/er for correct information.
l
TWO VOLTAGE I IOV
ELECTORS _2o-127v
Z40V 2 OV
I IOV )20-127V
£
L_
o
>
CAUTION:TWO VOLTAGESELECTORS
AC 110V AC 120
AC220V AC 240V
-127V
1IOV 120-127V 220V 240V
11or
12OV-127V
×
x
L_.
Z20v
240v
_CHANNELSTEP)
NOTE:
Both switches must be in the same switch
setting; otherwise, unit can be damaged.
4
<ARB1466_