User manual

1313
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
Setting Item Default Value Setting Details
Surr Back Right 0.0 dB Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
•
This setting cannot be changed if "System
Setup" - "Speaker" - "Configuration" - "Zone
Speaker" is set to "Zone 2".
Surr Back Left 0.0 dB Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
•
This setting cannot be changed if "System
Setup" - "Speaker" - "Configuration" - "Zone
Speaker" is set to "Zone 2".
Surround Left 0.0 dB Select a value between "−12.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
Subwoofer 0.0 dB Select a value between "−15.0 dB" and "＋12.0
dB" (in 0.5 dB increments). A test tone will be
output each time you change the value. Select the
desired level.
■ Dolby Enabled Speaker
Setting Item Default Value Setting Details
Dolby Enabled
Speaker to
Ceiling
(6.0ft/1.80m) Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between
"0.1ft/0.03m" to "15.0ft/4.50m" (0.1ft/0.03m units).
•
The unit of distance (ft/m) shown is the unit
selected for use in "Distance".
Reflex Optimizer (Off) You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": Do not use this function
"On": Use this function
•
It cannot be set if the mode is Direct or Pure
Direct.