User Guide

English
Connecting the Power Cable
• Be sure to disconnect the ⊖ terminal of the vehicle’s battery before connecting the power cable.
• The product should be installed by authorized service company personnel who have special training and
experience with mobile electronics products.
By using the power cable to draw power directly from the vehicle, this product can detect and record vehicle movement
caused by vibration even when the vehicle’s engine is turned off.
Black 0.5 m/1 ft. 8 in.
Yellow 0.5 m/1 ft. 8 in.
Red 0.5 m/1 ft. 8 in.
4.5 m/14 ft. 9 in.
Fuse
(F 2 AL/250 V)
Fuse
(F 2 AL/250 V)
Black 5 m/16 ft. 5 in.
Ground (Black)
Securely connect to the metal part of the vehicle body. To
prevent noise, connect as close to the navigation unit as
possible.
+ Battery power supply (Yellow)
Always connect to the power circuit supplied with power
from the battery, regardless of whether the vehicle engine
switch is ON or OFF.
Accessory power supply (Red)
Connect to the power circuit supplied with power when the
vehicle engine switch is turned to the ACC position.
Never install the accessory power supply to a vehicle that
does not have an ACC position on the engine switch. Doing
so may lead to a dead battery.
Note:
Connect the red and yellow lead wires to the terminals
after wiring through the vehicle’s fuse unit.
Connection Precautions
To prevent fuming and damage to the product, be sure
to first securely connect the black lead wire (Ground) of
this product to the metal part of the vehicle body. Connect
separate black lead wires (Ground) for products with a
high current consumption such as a power amplifier. When
setting up connections all at once, there is a risk of fuming
or damage to the product when screws loosen or come off
completely.
Black lead wire (Ground)
Metal part of the vehicle body
*1
*1 Not supplied for this unit
*1
4 Connect the Dash Camera main unit,
power cable, and 2nd camera connection
cable.
2nd camera
2nd camera connection cable
Power cable
Main Unit
5 Route the power cable and 2nd camera
connection cable along the passenger
side.
シガーライター
電源ケーブル
アクセサリー
ソケット
Main Unit
2nd camera
Connection cable
6 Connect the power cable.
→
“Connecting the Power Cable”
7 Turn the vehicle engine on to display the
recording screen.
8 Adjust the angle of the lens so that video
outside and inside the vehicle is properly
displayed.
Turn the angle adjustment
jog dial to adjust the lens
angle.
Turn this part to adjust
the lens angle.
Before driving, turn the lens of this product towards
the outside of the vehicle.
This product restarts when the lens angle is moved
from the outside of the vehicle to the inside, and vice
versa.
To switch between camera video from this product
and video from the 2nd camera, press the
button. →
“Function Buttons”
Note
• A protective film is applied to the lens when the
product is purchased. Peel off this film.