User Manual
Table Of Contents
-  Precaution
-  Disclaimer
-  How to read this Manual
-  Usage Precautions
-  Check the Accessories
-  Before Installing the Product
-  Installation
-  Connecting the Power Cable
-  Part Names
-  Inserting and Ejecting the microSD Card
-  Backing Up Recorded Files
-  Using this product
-  This Product’s Settings
-  Guide to Recording Time and No. of Photos
-  Dedicated App
-  Trademarks & Copyrights
-  GPS
-  Troubleshooting
-  Specifications
− 17 −
English
•Firmly push the area around the LCD. Next, remove this product from the mounting bracket, and
directly press the mounting bracket against the tape. In this way, the product can be firmly installed
on the windshield.
•Never touch the surface of the LCD.
•Use extreme care as the double-sided tape on the mounting bracket is extremely strong, and it will be
difficult to reapply the tape once it has been applied.
•To ensure the installation strength of the adhesive tape, leave this product for 24 hours after application
before using it.
3 Install the 2nd camera.
①: Peel off the double-sided tape release paper from the 2nd camera.
②: With the flat part shown in the figure facing up (position where the △ mark on the side is facing
up), install the 2nd camera at the specified position on the rear windshield.
1
2
Install with the
flat surface facing
upwards.
Face the lens towards the outside of the
car and firmly push.
4 Connect the power cable, 2nd camera connection cable and AV cable to this
product.
2nd camera
2nd camera connection cable
Power cable
AV Cable
Main Unit
Notes
•Connecting the AV cable is only required if connecting the VREC-DZ700DC to a compatible stereo
with an AV Input.