User's Manual

Controls and displays
02
10
En
1 VOLUME +/–
Press to adjust the volume of the wireless
speaker (and subwoofer, if connected).
2 CHANNEL
In case of poor reception due to interference
from other electrical devices, you can improve
reception by selecting another channel. Each
time you press the button, the channel
changes sequentially:
Note
• Poor reception may cause the audio to be
interrupted or stopped. This is not a
malfunction. Try changing the location or
orientation of the transmitter and/or the
wireless speaker to improve reception.
• See also
Placing the wireless speaker
system
on page 20, Radio wave reflections
on page 23 and
Scope of operation on
page 24 for more on reception
troubleshooting.
3 SURROUND MODE
Press to switch the surround mode. See the
tip on page 19.
Note
• Since the surround modes work in
conjunction with the corresponding input
(
DVD
or
TV
), make sure the mode you’ve
selected corresponds with the input
source.
4 VOLUME / CHANNEL indicators
Shows the volume level of the wireless
speaker (does not light when
WIRELESS
OFF
is selected). Also, after selecting a
channel, the corresponding channel
indicator blinks briefly.
Note
• The decibel level for each LED in the
volume indicator is shown below.
5 DVD input mode indicators
Light to indicate the surround mode set for
the DVD input (
CS II CINEMA
,
CS II MUSIC
or
W.STEREO
). See DVD input surround
modes
on page 17.
6 TV input mode indicators
Light to indicate the surround mode set for
the TV input (
CINEMA
,
MUSIC
or
W.STEREO ). See TV input surround modes on
page 18.
7 WIRELESS OFF indicator
Lights when sound from the wireless speaker
is switched off.
8 ATT/MUTE indicator
Lights when output to the wireless speaker is
being attenuated. Blinks when output is
muted.
9 Remote sensor
Receives the signals from the remote control.
• Make sure that there are no obstacles
between the remote and the remote
sensor on the unit.
• The remote has a range of about 7 meters,
within 30º of the remote sensor.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit's remote sensor.
10 Transmitter antenna
Transmits signals to the wireless speaker.
CH 2 CH 3 CH 4
CH 1
VOLUME
(1–10) (11–20) (21–30) (31–40) (41–50)
En_XW-HT1.book 10 ページ ２００４年６月２１日 月曜日 午前１０時４９分