User Manual

Controls and Displays 02
11
En
English
1 CHANNEL INDICATORS
Light to indicate the selected channel.
2 CHANNEL
The default setting is CH1. In case of poor
reception due to interference from other
electrical devices, you can improve reception
by selecting another channel. Each time you
press the button, the channel changes
sequentially:
Each of the 4 channels is allocated a
frequency as follows:
• CHANNEL 1 - 2.414GHz
• CHANNEL 2 - 2.432GHz
• CHANNEL 3 - 2.450GHz
• CHANNEL 4 - 2.468GHz
• Poor reception may cause the audio to be
interrupted or stopped. This is not
malfunction. Try changing the location or
orientation of the transmitter and/or the
wireless speaker to improve reception.
3 Antenna
Transmits signals to the wireless speaker.
4POWER
Press to switch the unit on or off.
5TUNED
Lights when the signal from the transmitter is
properly received.
6 WIRELESS MODE
Slide to select either SURROUND or STEREO
mode.
SURROUND - Sounds going to the surround
left and right channels are heard through the
wireless speakers.
STEREO - Any source playing through the
main system is heard in stereo through the
wireless speakers (multi-channel sources will
be downmixed to stereo).
• Before switching to either mode, stop the
DVD receiver.
• If the DVD receiver and wireless speaker
modes do not match, the wireless
speaker system may produce loud sound.
• When set to SURROUND, the STEREO
MODE VOLUME control does not
function.
7 CHANNEL button
• XW-DV515
The default setting is AUTO ON. Press and
hold for more than 5 seconds to switch
between AUTO ON and AUTO OFF.
The reception channel is temporarily locked
when set to AUTO OFF. Switching to AUTO
OFF may improve reception in some cases.
When the POWER is turned off, the
CHANNEL setting reverts to AUTO ON.
Normally, use the AUTO ON setting.
• When AUTO ON is selected, the same
channel as the transmitter is selected
automatically.
CH 2 CH 3 CH 4
CH 1
WSS.book Page 11 Friday, March 7, 2003 5:57 PM