User manual

17
En
Adjusting the Sound Quality
By pressing BASS, TREBLE, etc. on the
remote controller during play, you can
adjust frequently used settings, such as the
sound quality.
0 BALANCE adjustments can only be
made with the buttons on the main unit.
∫ BASS (a)
Enhance or moderate the bass range of the
speakers.
Select between j5 and i5 in 1 dB
increments. (default value: 0)
0 It cannot be set if the DIRECT mode is
selected.
∫ TREBLE (b)
Enhance or moderate the treble range of
the speakers.
Select between j5 and i5 in 1 dB
increments. (default value: 0)
0 It cannot be set if the DIRECT mode is
selected.
∫ DIRECT (c)
Switch to the DIRECT mode which outputs
pure sound as it was intended by
bypassing the tone control circuits during
play.
∫ TONE (d)
Switch to the TONE mode which enables
BASS and TREBLE.
∫ P.BASS
P.BASS is enabled which emphasizes the
bass. Repeatedly press TONE (d) to
display "P.BASS", then press the Left/Right
cursors to switch On or Off. (Default value:
Off)
∫ BALANCE (main unit only)
Adjust the balance of the sounds output
from the left and right speakers.
Select between Li10 and Ri10 in 1 steps
increments. (default value: 0)
> Before Start > Part Names > Install > Playback
Setup | Others
c
d
a
b
SN29403247_SX-10AE_En_1707XX.book 17 ページ ２０１７年７月１９日 水曜日 午後１時５９分