Installation Manual

Installation Installation
• When installing, to ensure proper heat
dispersal when using this unit, make
sure you leave ample space behind the
rear panel and wrap any loose cables so
they are not blocking the vents.
Leave ample
space
5 cm
5 cm
• Do not squeeze this product into the
holder
. It may damage the front panel.
P
arts supplied
The display unit
Flush sur
face screw
(5 mm × 9 mm)
(6 pcs.)
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Installation using the scr
ew holes
on the side of this product
1 F
asten the unit to the factory radio-
mounting brack
et.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three or four lo-
cations on each side. Use either the truss
head screws (5 mm × 8 mm) or flush sur
face
screws (5 mm × 9 mm), depending on the
shape of the bracket’s screw holes.
If the tab inter
feres with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Truss head screw or
flush surface screw
Be sure to use the
screws supplied
with this product.
Dashboard or console