Installation Instructions

3
3.2.1 Preparations .................................................................................................................................. 13
3.2.2 Detecting the Magnet Position ..................................................................................................... 13
3.3 Magnet Calibration （Using the SGX-CA500） ................................................................................. 14
3.3.1 Preparations .................................................................................................................................. 14
3.3.2 Detection of Magnet Position ........................................................................................................ 14
3.3.3 Fixing the Magnets ........................................................................................................................ 15
3.3.4 Magnet Calibration ....................................................................................................................... 15
4 Pairing with the Cyclocomputer ................................................................................................................. 16
4.1 Check the sensor modes. ...................................................................................................................... 16
4.2 Rotate the crank at least three times to start up both sensors. ......................................................... 16
4.3 Select the Sensor to connect on the Cycle Computer SGX ................................................................. 16
4.4 Press [Search]. ...................................................................................................................................... 17
5 Zero Calibration ........................................................................................................................................... 18
5.1 Select Zero Calibration. ........................................................................................................................ 18
5.2 Start Zero Calibration (Press [ZeroCal]) ............................................................................................. 18
5.3 Checking the Calibration Results ........................................................................................................ 19
5.3.1 Check that the crank is detecting no load. ................................................................................... 19
6 Copy pedal .................................................................................................................................................... 20
6.1 Press the menu button on the CycloMeter screen. .............................................................................. 20
6.2 Tap [Option] then [Pedaling settings] and then [Pedaling Copy].,and select the copy method. ....... 20
6.3 To change the balance, tap [L:R Balance]. ........................................................................................... 20
6.4 Tap [+], [-] and change the numerical value and tap [OK]. ................................................................ 20
7 Operation Check(Using the SGX-CA500 only) ........................................................................................... 21
8 Troubleshooting ........................................................................................................................................... 22
9 Error Code (Using the SGX-CA500) ........................................................................................................... 26