Installation Instructions

25
Question Answer
Once the count increasing with
each rotation has been confirmed,
with the magnets attached
temporarily, Fix the magnets in place
and press the [Measure] button. The
display will show the count as 0/5.
Rotate the crank until the display
count is shown as 5/5, then the
[Save] button will become available.
Magnet Calibration must be
completed within thirty minutes. If it
is not, the system will revert to
normal mode. Use the [Back] button
to end the Magnet Calibration Tool
then start again. Removing or
replacingthe battery also causes
Magnet Calibration Mode to be
released.
The SGY-PM910HL or
910HR only shows vector
data for one side.
It is necessary to set up the Pedal
Copy function in the SGX-CA500.
With the 910HL, copy Left to Right,
with the 910HR, copy the Right side
to the Left.. [Options] -> [Pedaling
Settings] -> [Pedal Copy]. If this
cannot be found in the menu, please
update the SGX-CA500 cycle
computer firmware to the latest
version.
The sensor firmware
cannot be updated.
Check the firmware version in
[Options] -> [Pedaling Settings] ->
Sensor Firmware Version] If this
cannot be found in the menu, please
update the SGX-CA500 cycle
computer firmware to the latest
version.
Update an take up to fifteen minutes
to complete.
In Magnet Calibration
Mode on the SGX-CA500,
the results of the
calibration cannot be
stored.
Cyclecomputer