Installation Instructions

2
Table of Contents
Table of Contents ............................................................................................................................................... 2
1 Preparations ................................................................................................................................................... 4
1.1 Confirm the products .............................................................................................................................. 4
1.2 Outline of procedure ............................................................................................................................... 4
1.2.1 For the SGY-PM910HL/HR with an ANT+ cycle computer ........................................................... 4
1.2.2 For the SGY-910H2/(HL+HR) with an ANT+ cycle computer ....................................................... 4
1.2.3 For the SGY-PM910HL/HR/(HL+HR)/H2 with a SGX- CA500 ..................................................... 5
1.3 Product mode .......................................................................................................................................... 6
Pedaling monitor mode: ................................................................................................................................. 6
•Dual power meter mode: ............................................................................................................................. 6
Single power meter mode: ............................................................................................................................. 6
The power value of the left or right sensors can be doubled and displayed quickly and the cadence can be
measured. Can be used with SGX-CA500 or with a Cyclocomputer that supports ANT+ from another
manufacturer ................................................................................................................................................. 6
2 Mode Select .................................................................................................................................................... 6
2.1 Switching to the pedaling monitor mode• ............................................................................................. 6
2.1.1 Press the menu button on the CycloMeter screen of SGX-CA500. ................................................ 6
2.1.2 Tap [Option] - [Pedaling settings] - [Mode Switch] in this order. .................................................. 6
2.1.3 Tap on the device number display part. ......................................................................................... 6
2.1.4 Enter the device number and tap [ ]. .................................................................................... 7
2.1.5 Rotate the bicycle’s crank set more than three rotations to start the left and right transmitters.
7
2.1.6 Tap [Pedaling Monitor]. .................................................................................................................. 7
2.1.7 Add in the sensor list of SGX-CA500 .............................................................................................. 7
2.2 Switch to dual power meter mode .......................................................................................................... 8
2.2.1 [Method 1] Switch by pushing the push switch in the right transmitter ..................................... 8
2.2.2 [Method 2] Switch the mode on SGX-CA500 ................................................................................ 10
2.3 Switch to single power meter mode ..................................................................................................... 11
2.3.1 [Method 1] Switch by pushing the push switch in the right transmitter ................................... 11
2.3.2 [Method 2] Switch the sensor mode from SGX-CA500 ................................................................ 11
3 Magnet Detection and Calibration .............................................................................................................. 12
3.1 Temporarily affix the Magnet .............................................................................................................. 12
3.1.1 Use masking tape to temporarily attach the Magnet Patch ....................................................... 12
3.1.2 Rotate the rank to confirm the position of the magnets. ............................................................. 12
3.1.3 Temporarily affix the Magnet. ...................................................................................................... 13
3.1.4 Turn the crank slowly. ................................................................................................................... 13
3.2 Magnet Detection (For cycle computer other than Pioneer) ............................................................... 13