Instruction Manual

When the system is on and functioning, the system is designed to detect the following events:
1. Blind spots while driving: Objects in the blind spot areas around your vehicle-in the lanes on the
left/right and directly behind the vehicle at a distance of up to 82 ft (approximately 25 m).
2. Blind spots while being passed / overtaken: When vehicles are approaching / overtaking your vehicle
from behind, or when your vehicle approaches and passes a moving vehicle.
3. Cross-Traffic Detection: When your vehicle is reversing, vehicles approaching from your left and
right.
Alert Conditions
System Indicators
A. When the system is turned on each time (your vehicle ignition or ACC is switched on), both LED
indicators will flash once to indicate system start up and initialization. Once a GPS connection is
established, which may take up to 2 minutes, both LED indicators will flash twice to indicate the
system is ready for use. The GPS connection is used to calculate your vehicle's speed.
When your vehicle is traveling slower than the start speed setting 18mph(29km/h), the system will
not produce warnings.
B.
1. The Right LED indicator will illuminate and remain illuminated when there is an object or vehicle
approaching,
2. If your vehicle's right turn signal is activated when there is an object or vehicle approaching,
the Right LED indicator will flash
repeatedly and the included .
C.
1. The Left LED indicator will illuminate and remain illuminated when there is an object or vehicle
approaching, or when your vehicle approaches and passes a moving vehicle.
2. If your vehicle's left turn signal is activated when there is an object or vehicle approaching,
, the Left LED indicator will flash
repeatedly and the
Blind spot detection toward the right rear of your vehicle:
speaker will beep (bi-bi-bi) one time
Blind spot detection toward the left rear of your vehicle:
speaker will beep (bi-bi-bi) one time
or when your vehicle approaches and passes a moving vehicle.
or
when your vehicle approaches and passes a moving vehicle,
or
when your vehicle approaches and passes a moving vehicle
included .
D. Cross-Traffic Detection:
1. When your vehicle is reversing and the system detects an object or vehicle approaching from your
right, the right LED indicator will illuminate and remain illuminated and the included speaker will
beep repeatedly.
-6-
CAUTION
The SDA-BS900 can not only objects approaching your vehicle from behind, but also detect
objects your vehicle is approaching or overtaking. Under certain driving scenarios, the SDA-BS900
may detect objects in an unintended way. The following conditions below are examples of scenarios
where fault notifications may occur
detect
.
Fig 1
Fig 2
Fig 3
Fig 4
English