Instruction Manual

When the system is on and functioning, the system is designed to detect the following events:
1. Blind spots while driving: Objects in the blind spot areas around your vehicle - in the lanes on the
left/right and directly behind the vehicle at a distance of up to 50 ft (approximately 15.2 m).
2. Blind spots while being passed / overtaken: When vehicles are approaching / overtaking your vehicle
from behind.
3. Cross-Traffic Detection: When your vehicle is reversing, vehicles approaching from your left and
right.
Alert Conditions
CAUTION
The SDA-BS100 only detects objects approaching your vehicle from behind. It does not detect objects
your vehicle is approaching or overtaking. Under certain driving scenarios, the SDA-BS100 may detect
objects in an unintended way. The following conditions below are examples of scenarios where fault
notifications may occur.
System Indicators
A. When the system is turned on each time (your vehicle ignition or ACC is switched on), both LED
indicators will flash once to indicate system start up and initialization. Once a GPS connection is
established, which may take up to 2 minutes, both LED indicators will flash twice to indicate the
system is ready for use. The GPS connection is used to calculate your vehicle's speed.
The system features a sensing speed threshold that is set when the system is installed. When your
vehicle is traveling slower than this threshold setting, the system will not produce warnings.
Threshold 1: System warns at any speed above 5 mph (8 km/h)
Threshold 2: System warns at any speed above 10 mph (16 km/h)
Threshold 3: System warns at any speed above 15 mph (24 km/h)
Threshold 4*: System warns at any speed above 20 mph (32 km/h)
*The factory default sensing speed threshold is Threshold 4.
B.
1. The Right LED indicator will illuminate and remain illuminated when there is an object or vehicle
approaching.
2. If your vehicle's right turn signal is activated when there is an object or vehicle approaching, the
Right LED indicator will flash repeatedly and the included speaker will beep (bi-bi-bi) one time.
C.
1. The Left LED indicator will illuminate and remain illuminated when there is an object or vehicle
approaching.
2. If your vehicle's left turn signal is activated when there is an object or vehicle approaching, the
Left LED indicator will flash repeatedly and the included speaker will beep (bi-bi-bi) one time.
Blind spot detection toward the right rear of your vehicle:
Blind spot detection toward the left rear of your vehicle:
-6-
Fig 1 Fig 2 Fig 3 Fig 4
English