Instruction Manual

Important Safety Information
The license plate bar’s performance can be affected if installed on a vehicle that has items
obstructing the license plate location (e.g. bike rack, trailer). In addition, the license plate bar
cannot be installed correctly if the license plate is offset or on the far side of the vehicle and not
centered.
This system can be used on any vehicle that has a standard license plate location but can be affected
by metal objects that may block or interfere with the operation of the system.
The following may compromise the effectiveness of the system:
Vehicles with permanent trailers attached.
Vehicles with metal obstructions in front of the license plate, i.e. spare tire mount, rear bike racks
or equipment for disabled persons.
Standard license plates that are mounted on the right or left side of the vehicle.
(Center Installation Required)
Situations that cannot be detected
If a vehicle is passing your vehicle.
Your vehicle is moving slower than the sensing speed threshold setting, such as in slow moving
traffic.
When your vehicle is reversing, the relative speed between your vehicle and objects is less than
5 mph (8 km/h).
If a vehicle is approaching / overtaking your vehicle and the relative speed between your vehicle
and the overtaking vehicle is greater than 50 mph (80 km/h). For example, if you are traveling at
55 mph (88 km/h), the system cannot detect vehicles approaching from behind if their speed
exceeds 105 mph (169 km/h).
Situations that may affect system detection accuracy
Metal objects are in the direct path of the sensing signal.
Weather such as heavy rain and snow, and icy road conditions, which can cause changes in
sensitivity.
Gravel roads, which may cause interference due to dust and flying stones.
・
・
・
・
・
・
・
・
・
・
・
・
THIS PRODUCT FUNCTIONS AS AN AID
FOR NOTIFYING THE PRESENCE OF OBSTACLES IN VEHICLE BLIND SPOTS.
IT DOES NOT DETECT ALL DANGERS AND OBSTACLES
AND IS NOT A SUBSTITUTE FOR YOUR JUDGEMENT AND CAREFUL ATTENTION.
BEFORE ANY MANEUVER, VISUALLY CHECK BOTH SIDES OF THE VEHICLE TO CONFIRM.
WARNING
WARNING
Check license plate bar unit installation before driving.
- Are the screws loose?
- Is the unit firmly secured?
- If the unit comes loose while you are driving, it may cause an accident.
・
-4-
CAUTION
・Special vehicle conditions that should be considered
During system startup and initialization, it may take up to 2 minutes for the system to establish a GPS
connection. If the vehicle is driven before a GPS connection is established or if the GPS connection is
interrupted (inside a tunnel, parking structure, etc.), the system may not function properly, producing
incorrect or false warnings or failing to produce a warning. Once the GPS connection is established
or re-established, both LED indicators will flash twice to indicate the system is ready for use.
English