Instruction Manual

-16-
NO.
Issues
Reasons
Solutions
1
Incorrect connection or pins
not making contact
LED light is broken Replace LED light
2
Make sure RED is on the left side and
YELLOW is on the right side if
installed at the bottom of the
License Plate.
If the is installed in
the top position, the sensor wires
must be reconfigured during
installation.
License Plate Bar
3
4
5
Troubleshooting
LED light does not
work
Check the
sure connection is correct
harness and make
Opposite LED
indicator
Microwave sensor or LED
indicators are plugged in
to the opposite connector
Speaker does not work
Wrong connection or pins
not making contact
Check the harness and make
sure connection is correct
Defective Speaker
Replace Speaker
Sensor or GPS
does not work
Sensor or GPS Antenna module
is covered by the metal
bumper or other metal
Find the best location where the
sensor or GPS Antenna cannot be
blocked by any metal
Unit does not work
after GPS Antenna is
connected
Blind spot system does not
trigger the sensor if the speed
is less than 20 mph (32 km/h)*
The system features sensing speed
threshold settings of 5 mph, 10 mph,
15 mph or 20 mph. The factory
default setting is 20 mph (32 km/h).
The setting can be changed by the
installer.
6
7
FUSE is blown
Over current / Power surge Exchange FUSE (2 A)
Blind area object
detection not
consistent or unstable
Not Installed in center
(See Fig 17)
Find the location in the center
of vehicle.
Find the location where the radar
sensing area is not blocked by
objects(s).
**
Installed with wrong angle
(pointing upward)
Installed at a location with
object in front (See Fig18)
* U
** This product can be installed on almost any vehicle, not limited to the license plate location, as long
as the installation location is in the center of the vehicle and meets the angle and other installation
location requirements.
nder the default setting, GPS restriction speed can be changed according to the four speed
threshold options; please refer to Speed Restriction, Page 15.
English
Fig 17 Fig 18