Owner's Manual

Mounting to Dashboard
•
Protective film is affixed to the suction surface
(back side) of the suction cup. Do not peel off
the film until step 10. If the suction surface of the
suction cup becomes dirty, the suction power will
be reduced and the product may fall.
•

Select the following location to install the
product. If the product is not installed correctly,
it will fall, etc.
* Smooth and level location on the dashboard
* Location where the entire suction surface can
be affixed
•
Be sure to attach the supplied safety strap to
prevent the product from falling.
1
Turn the nut counterclockwise
and remove it.
2
Assemble the dashboard
mount attachment and
nut, and insert them into
the attachment hole of the
product.
3
Fix them in place by turning
the nut clockwise.
4
Determine the mount position.
Deter mine the mount position of the product
by plac
ing the attachment on the dashboard
without removing the film.
5
Adjust the angle and height.
Loosen each of the screws for the angle 1
and height 2, make adjustments, and then
tighten the screws.
1
2
6
Pass the safety strap through
the hole in the suction cup
surface mount sheet and
fasten the strap.
Pass the shortest loop of the safety strap
through the hole in the suction cup surface
mount sheet and fasten the strap.
Installation