Owner's Manual

Inserting and Removing a Smartphone
Inserting a Smartphone
1
Touch and hold the unlock
sensor.
Unlock
sensor
The sliding arms widen automatically.
If the product does not operate, start the
vehicle’s engine and then perform the
operation.
2
Insert your smartphone.
Always insert your smartphone by sliding it
from the top of the cradle as shown in the
figure.
Lock sensor
The lock sensor senses the smartphone and
the sliding arms close automatically.
Note
󱦬 Take precaution that your hand does not get
caught between the phone and the sliding
arms when the sliding arms are closing.
Once a compatible smartphone is inserted,
wireless charging will start automatically.
The charging lamp will illuminate during
charging. For details on illumination status,
see “Product Status Display”.
Charging lamp
In the following cases, adjust the length of the
holder from the bottom of the cradle.
•
If a sliding arm is pressing the power
button or volume button of the
smartphone.
•
If the charging indicator does not light
even though a compatible smartphone is
inserted.