Specification Sheet

IftheUSBstoragedevicehasbeenpartitioned,eachsectionwillbetreated
asanindependentdevice.
5. Press ontheremotecontroller.
TheHomescreenisdisplayedontheTVscreen.
6. Select"SystemSetup""Miscellaneous""FirmwareUpdate""Updatevia
USB"withthecursorsinorder,thenpressENTER.
If"FirmwareUpdate"isgrayedoutandcannotbeselected,waitforawhile
untilitstartsup.
Youwillnotbeabletoselect"UpdateviaUSB"ifthereisnothingtoupdate.
7. PressENTERwith"Update"selectedtostartupdate.
Duringtheupdate,theTVscreenmaygoblackdependingontheupdated
program.Inthatcase,checktheprogressonthedisplayoftheunit.TheTV
screenwillremainblackuntiltheupdateiscompleteandthepoweris
turnedonagain.
Duringtheupdate,donotturnoff,ordisconnectthenreconnecttheUSB
storagedevice.
"Completed!"isdisplayedwhentheupdateiscomplete.
8. DisconnecttheUSBstoragedevicefromtheunit.
9. Press STANDBY/ONonthemainunittoswitchtheunittostandby.The
processiscompletedandyourfirmwareisupdatedtothelatestversion.
Donotuse ontheremotecontroller.