Specification Sheet

Whenthissettingischanged,allradiopresetsaredeleted.
AMNoiseCutMode
DefaultValue:1
Youcanimprovereceptionsensitivitybychangingthismodeifyouarefinding
AMbroadcastsdifficulttohear.Select"1"or"2".
RemoteID
RemoteID
DefaultValue:1
SelectanIDfortheunit'sremotecontrollerfrom"1","2",and"3"toprevent
interferencebetweentheunitandotherPioneercomponentsthatare
installedinthesameroom.AfterchangingtheIDonthemainunit,change
theIDontheremotecontrolleraccordinglywiththefollowingprocedure.
WhileholdingdownMODE,pressthefollowingbuttonsforabout3seconds.
TochangetheremotecontrollerIDto"1":
(Theremoteindicatorflashesonce.)
TochangetheremotecontrollerIDto"2":
(Theremoteindicatorflashestwice.)
TochangetheremotecontrollerIDto"3":
(Theremoteindicatorflashesthreetimes.)
FirmwareUpdate
UpdateNotice
DefaultValue:Enable
Availabilityofafirmwareupdatewillbenotifiedvianetwork.
"Enable":Notifyupdates
"Disable":Donotnotifyupdates
Version
DefaultValue:‐
Thecurrentfirmwareversionwillbedisplayed.
UpdateviaNET
DefaultValue:‐
PressENTERtoselectwhenyouwanttoupdatethefirmwarevianetwork.
YouwillnotbeabletoselectthissettingifyoudonothaveInternet
accessorthereisnothingtoupdate.
UpdateviaUSB
DefaultValue:‐
PressENTERtoselectwhenyouwanttoupdatethefirmwareviaUSB.