User manual

35
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
Setting Item Default Value Setting Details
Height 2 Right 10' 0" / 3.00 m The test pulse is output from this speaker and
the benchmark Front Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
•
Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
Surround Left 10' 0" / 3.00 m The test pulse is output from this speaker and
the benchmark Front Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Surround Right 10' 0" / 3.00 m The test pulse is output from this speaker and
the benchmark Front Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Surr Back Left 10' 0" / 3.00 m The test pulse is output from this speaker and the
benchmark Surround Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
•
Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
Surr Back Right 10' 0" / 3.00 m The test pulse is output from this speaker and the
benchmark Surround Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
•
Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
Subwoofer 1 10' 0" / 3.00 m The test pulse is output from this speaker and
the benchmark Front Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Subwoofer 2 10' 0" / 3.00 m The test pulse is output from this speaker and the
benchmark Subwoofer 1, so adjust the distance
so the point where the test pulse is heard is in the
middle of the two speakers.
•
Default values vary depending on the regions.
•
Distance units can be switched by pressing MODE on the remote controller. When the unit is set as
feet, you can set between 0' 0" 1/2 and 30' 0" in increments of 1/2. When the unit is set as meters,
you can set between 0.01 m and 9.00 m in increments of 0.01 m.