User manual

17
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
■ Dolby Enabled Speaker
Setting Item Default Value Setting Details
Dolby Enabled
Speaker to
Ceiling
6' 00" / 1.80 m Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between " 0' 0" 1/2
"/"0.01 m" to " 15' 0" "/"4.50 m" (1/2 / 0.01 m units).
•
The unit of distance (feet / meters) shown is the
unit selected for use in "Distance".
Reflex Optimizer Off You can enhance the reflection effect of Dolby
Enabled Speakers from the ceiling.
"Off": Do not use this function
"On": Use this function
•
The function is not effective if the listening mode
is Pure Direct.
•
This setting can be selected when "System Setup" - "Speaker" - "Configuration" - "Height 1
Speaker"/"Height 2 Speaker" is set to "Dolby Speaker".
Audio Adjust
Make advanced settings such as those related to multiplex audio or those related to the
volume of this unit.
■ Dual Mono/Mono
Setting Item Default Value Setting Details
Dual Mono Main Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be output
at the same time.
•
If multiplex audio is being played, "1＋1" will be
displayed when
on the remote controller is
pressed.
Mono Input
Channel
Left+Right Set the input channel to use for playing any 2 ch
digital source such as Dolby Digital, or 2 ch analog/
PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left+Right": Left and right channels
■ Dolby
Setting Item Default Value Setting Details
Loudness
Management
On When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume
of dialog at a certain level. Note that when this
setting is Off, the DRC function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": Use this function
"Off": Do not use this function