User manual

12
> Specifications > Advanced Setup > Listening Modes
> Network Functions > Basic Manual
|Troubleshooting Supplementary Information, etc.
Setting Item Default Value Setting Details
Surround Back Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
•
When "Surround" is set to "Small", this is set to
"Small".
•
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Crossover 80Hz When there are speakers that have been set to
"Small", set the Hz under which you would like
other speakers to play bass, and also set Hz under
which you would like the LFE (low frequency effect)
to play the bass.
The value from "50Hz" to "200Hz" can be set.
Double Bass Off This can be selected only when "Configuration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Large".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
•
The setting will not automatically be configured
even if you performed Full Auto MCACC.
■ Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value Setting Details
Front Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Center 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Setting Item Default Value Setting Details
Front Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Height Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set
in "Configuration" - "Zone Speaker" and Zone 2
is on.
Height Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set
in "Configuration" - "Zone Speaker" and Zone 2
is on.
Surround Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Surr Back Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Surr Back Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Surround Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Subwoofer 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
•
Default values vary depending on the regions.
•
Distance units can be switched by pressing MODE on the remote controller. When the unit is set as
feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1ft. When the unit is set as meters, you
can set between 0.03 m and 9.00 m in increments of 0.03 m.