RD-HWK200 HARDWIRE KIT TROUSSE D’ALIMENTATION PERMANENTE Installation Manual Manuel d’installation PIONEER CORPORATION 28-8, Honkomagome 2-chome, Bunkyo-ku, Tokyo 113-0021, Japan PIONEER ELECTRONICS (USA) INC. P.O. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404 ©2021 PIONEER CORPORATION.
English Information to User Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
After-sales service for Pioneer products Please contact the authorized Pioneer dealer from which you purchased this unit or an authorized Pioneer service company for aftersales service or questions you may have about the product. You may contact Pioneer directly as follows: Do not ship your unit in for repair without contacting Pioneer first. Units sent without a return authorization number will be refused. USA & CANADA Pioneer Electronics (USA) Inc. CUSTOMER SUPPORT DIVISION P.O.
Note Product specifications and external appearance are subject to change without notice. Furthermore, the illustrations within this manual may differ from the actual product. Part Names and Status Indicators LED indicator Voltage cutoff/Timer off settings switch IRefer to "Settings". ACC linkage switch IRefer to "Settings". The product status is indicated by the illumination/flashing state of the LED indicator. If this does not light or flash as normal, try reconnecting.
English Before Installing the Product Installation Precautions Use the included double-sided tape to securely affix the product to the vehicle. Bottom surface Double-sided tape application position Recommended mounting locations are within the inside the kick panel or glove compartment. Mount on a flat, oil-free surface. Mounting on anything other than a flat surface may result in the product falling off. Additionally, there is a risk of malfunction.
Connecting Connection terminal connection and removal Connect the connection terminals securely. If the terminals do not go in smoothly, they may be reversed. Check the terminal orientation. Do not insert terminals with excessive force. Doing so may result in malfunction. When removing the connection terminals, hold the connector part to pull out. Pulling the cable may result in connector damage.
Settings Prior to using this product and the connected Dash Camera, configure the ACC linkage settings, voltage cutoff settings, and timer off settings. Voltage cutoff/Timer off settings switch Up: ON Down: OFF ACC linkage switch ACC linkage settings Operate the ACC linkage switch in accordance with the specifications of the Pioneer Dash Camera connecting to this product.
Voltage cutoff settings Move the voltage cutoff settings switches (3, 4) to set them depending on the vehicle battery voltage (12 V/24 V). When the vehicle battery voltage drops below the voltage cutoff settings value, the product will automatically stop operation. (Factory default: 11.8 V / 23.6 V) Switch position Voltage cutoff settings value (If vehicle is 12 V) 11.6 V 11.8 V 12.0 V 12.2 V Voltage cutoff settings value (If vehicle is 24 V) 23.2 V 23.6 V 24.0 V 24.
PIONEER ELECTRONICS (USA) INC. LIMITED WARRANTY WARRANTY VALID ONLY IN COUNTRY OF PRODUCT PURCHASE WARRANTY Pioneer Electronics (USA) Inc. (Pioneer) warrants that Pioneer® Car/Marine Electronics, Speaker, and Accessory Products distributed by Pioneer in the U.S.A.
PIONEER ELECTRONICS (USA) INC. GARANTIE LIMITÉE GARANTIE VALIDE UNIQUEMENT DANS LE PAYS D’ACHAT DU PRODUIT GARANTIE Pioneer Electronics (USA) Inc.
