Operating Instructions and Installation Instructions

12
Controls and Connectors
~=-
L
AC INLET
OFF ON
SPEAKER
8Ω ~16Ω
+ –
@! # $ % ^
AUDIO
INPUT5
INPUT3
S-VIDEO
RL
DIGITAL RGB
AUDIO
INPUT4
VIDEO OUTPUT
RL
1234 5 678
9
0
IN OUT
CONTROL
COMBINATION
IN OUT
RS-232C
ANALOG RGB (ANALOG RGB)
INPUT1
OUTPUT
GBRHDVD
(ON SYNC) (H/V SYNC)
Ô
75 2.2
Ω kΩ
INPUT
(INPUT1/2)
OUTPUT
R
SPEAKER
8Ω ~16Ω
+ –
INPUT2 AUDIO
Connection Panel
Plasma Display Section
1 SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16 Ω.
2 CONTROL IN/OUT (monaural mini jacks)
For connection of PIONEER components that bear
the Î mark. Making CONTROL connection enables
control of the main unit as a component in a
system.
(NOTE) The main unit cannot be operated by the
wired remote control RV-V107.
3 COMBINATION IN/OUT
Used when a number of sets are controlled
collectively. (See “5.6 Combination Connection”)
Please use a mini DIN 6 pin cable (straight, fully
connected) available on the market as the
connecting cable.
(NOTE) It has no ABL linking function. And it is not
compatible with the RM-V4000V or other
multi-projection. It is not output when the
main power is off.
4 RS-232C
This terminal is used for adjustments by a PC (EIA-
232-F standard).
(See “5.5 RS-232C Adjustment Mode”)
5 INPUT1 (mini D-sub 15 pin)
For connection of components that have RGB or
component
★
output jacks such as a personal
computer, DVD player, or external RGB decoder.
6 OUTPUT (INPUT1) (mini D-sub 15 pin)
Use the OUTPUT (INPUT1) connector to output the
video signal to an external monitor or other
component.
(NOTE) • The video signal will not be output from
the OUTPUT (INPUT1) connector when
the main power of this display is off or in
standby mode.
• When connecting the main units in a
series, please set the number that can be
connected as a total of 5 including the set
that the signal is initially input to. But a
condition for performing separate sink or
composite sink input and output is that
the sink level of the source used is at
least TTL level at 2.2kΩ terminal time.