User guide

Useful adjustment settings
-S
---- O® SLEE.P ?,
ooool
Ф
¿3
CD
C»3
CI3
Ф CD<D
® CD®
Ш1ШЯ:
®Л®1
MENU
ENTER
A/T
INPUT 1 signal menu Input Signal source
INPUT 2 signal menu
INPUT 3 signal menu
Input signal setting
For setting the signal type of external equipment.
1 Press MENU.
2 Press A/T to select “Option”, and then press
ENTER.
3 Press A/T to select “Input Select”, and then press
ENTER.
4 Press A/T to select an input source you want to
set, and then press ENTER.
5 Press A/V to select a signal type, and then press
ENTER
• If the selected signal type is incorrect, an image does
not display or no colour image displays.
6 Press MENU to exit the menu.
I NOTE >
• Return to the previous menu by pressing
• The System automatically sets input signals from “INPUT4”
and “PC”.
• If no (colour) image displays, try to change the signal
type.
• Check the operation manual of the external equipment
for the signal type.
Input selection
Can use for selecting the input source.
1 Press -Q on the remote control unit or INPUT on
the Plasma Display.
• INPUT SOURCE menu displays.
2 Hold down -Q on the remote control unit or INPUT
on the Plasma Display to select the input source.
• An image from the selected source automatically
displays.
• You can also select the input source by pressing А/
I NOTE >
• When there are no external sources connected to those
terminals, “INPUTS” (COMPONENT) or “INPUT4” will
display in gray and not be selectable.
• Return to the previous menu by pressing oT\.
(Ш)-49