Manual

TOPLAYONLYDESIREDTRACKS/DISCS
I To reserve the program I
Press the PGM button during normal playback.
The unit enters program mode and you can program while the
song is playing back.Program play starts when either the current
track finishes playback or • is pressed. Pressing • when the
program indicator is lit also starts program playback.
Programming a pause ]
Inserting a pause in your program can be very useful when carrying
out recording. Press II instead of entering a track number. "PAUSE"
appears in the display window.
• For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to allow
you to switch tape sides. To resume program playback after the
player enters pause mode, press II.
NOTES:
• A pause can be programmed only when the program procedure
is performed under stop mode.
a A pause cannot be programmed at the beginning of a program
(P-01), nor can two pauses be programmed one after the other.
• A pause inserted in a program is counted as one step.
I To erase a programmed step J
CLEAR
In the program mode, press CLEAR.
The last program step is erased and the contents of the previous
program step are displayed (for 5 seconds during playback)•
NOTE:
Tracks preceding the currently playing track cannot be erased during
program playback.
To Check the Program
or 0 0
• Play the program by pressing •.
2. Press either iH_ _ on the front panel or _ on the remote
control unit. The programmed disc and track numbers are displayed
and that program is played back• In the second programming step
or beyond, the previous step can be confirmed by pressing the
_ button of the main unit or the _ button of the remote
control unit.
• When an entire disc is programmed. For example, if all the tracks
on disc number 8 have been programmed, "8-01" is displayed,
not "8-AL".
16
<PRB1227>
En
To clear all of the program contents and to J
cancel the program mode
I
You can clear all of the program contents and cancel the program
mode by any of the following methods.
In the stop mode, press I1.
( I
//
In the program mode, select the other mode.
MODE
In the program mode, press RANDOM.
RANDOM
O
D
RANDOM
In the program playback, press DISC-/+.
- DISC +
O0
/?
DiSC ÷
y NOTE
Open the Rack. The programmed contents of discs m the Rack are
cleared• (The program mode is not canceled.)