Manual

ManualsBrandsPioneer ManualsAudio EquipmentOfficial Pioneer cd player

FILE-TYPE COMPACT DISC PLAYER

PD-F904

[ I ,',',.

_.ZS . " , _CJ

_i " , LJ C.J

IOD-DISC

DIGITAL AUDIO

POWER ON DEMO display]

POWER ON DEMO display mode allows you To cancel the POWER ON DEMO display

to see variations of the display. To enter the mode, press any button.

POWER ON DEMO display mode, press

POWER and then _ _ within 1 second

after turning on the power.

l hank you for buying this Pioneer product.

Please read through these operating instructions so you

will know how to operate your model properly. After you

have finished reading the instructions, put them away in a

safe place for future reference.

In some countries or regions, the shape of the power plug

and power outlet may sometimes differ from that shown in

the explanatory drawings. However, the method of

connecting and operating the unit is the same.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO

NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

IMPORTANT NOTICE

[For U.S. and Canadian models]

The serial number for this equipment is located on the rear panel.

Please write this serial number on your enclosed warranty card

and keep it in a secure area. This is for your security.

[For Canadian model]

CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE

THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,

RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN

BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

ATTENTION: POUR PREVENIR LES CHOCS ELECTRIQUES

NE PAS UTILISER CETTE FICHE POLARISEE AVEC UN

PROLONGATEUR, UNE PRISE DE COURANT OU UNE AUTRE

SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT ETRE

INSEREES A FOND SANS EN LAtSSER AUCUNE PARTIE A

DECOUVERT.

CAUTION:

This product satisfies FCC regulations when shielded cables and

connectors are used to connect the unit to other equipment. To

prevent electromagnetic interference with electric appliances

such as radios and televisions, use shielded cables and con nectors

for connections.

[For Canadian model]

This digital apparatus does not exceed the Class B limits for

radio noise emissions from digital apparatus set out in the

Radio Interference Regulations of the Canadian Department

of Communications.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging

the cord and never touch the power cord when your hands are wet

as this could cause ashort circuit or electric shock. Do not place the

unit, a piece of furniture, etc., on the power cord, or pinch the cord.

Never make a knot in the cord or tie it with other cords. The power

cords should be routed such that they are not likely to be stepped on.

A damaged power cord can cause a fire or give you a n electrical shock.

Check the power cord once in a while. When you find it damaged, ask

your nearest PIONEER authorized service center or your dealer for a

replacement.

]

This player isfor consumer use. If the player is used in abusiness

(for example, in a restaurant), the player will not be covered

under warranty.

PIONEER

The Art of Entertainment

Summary of content (20 pages)

PAGE 1
FILE-TYPE COMPACT DISC PLAYER PD-F904 IOD-DISC DIGITAL AUDIO _.ZS . " , _CJ _i " , LJ C.J [ I ,',',. O0 POWER ON DEMO display] POWER ON DEMO display mode allows you to see variations of the display. To enter the POWER ON DEMO display mode, press POWER and then _ _ within 1 second To cancel the POWER ON DEMO mode, press any button. display after turning on the power. l hank you for buying this Pioneer product.
PAGE 2
IMPORTANT CAUTION The lightning flash with,_ [_whead. within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage' within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
PAGE 3
[FOR U.S. MODEL] CAUTION • Use of controls or adjustments or performance exposure. • The use of optical instruments of procedures other than those specified with this product will increase eye hazard. herein may result in hazardous radiation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 4
CONTENTS CONFIRM SUPPLIED ACCESSORIES ................................ 5 PUT BATTERIES INTO THE REMOTE CONTROL UNIT .................................................................. 5 REMOTE CONTROL OPERATIONS ................................... 5 CAUTIONS REGARDING HANDLING ................................. 6 CONNECTIONS .................................................................. 7 NAMES AND FUNCTIONS OF PARTS ............................... 8 BEFORE OPERATING THE PLAYER ...........................
PAGE 5
CONFIRM SUPPLIED ACCESSORIES Open the lid of the battery compartment on the rear of the remote control unit, and insert the batteries, taking care to align the _) and (_ polarities correctly. ® ® L_ I PUT BATTERIESINTO THE REMOTE CONTROLUNIT NOTES: • In order to prevent battery leakage, remove the batteries when not using the remote control unit for an extended period (one month or more).
PAGE 6
CAUTIONS REGARDING HANDLING I I Location Install the unit in a well-ventilated When this unit is brought into a warm room from previously cold surroundings or when the room temperature rises sharply, condensation may form inside, and the unit may not be able to attain its full performance. To prevent this, allow the unit to stand for about an hour before switching it on, or raise the room temperature gradually. location where it will not be exposed to high temperatures or humidity.
PAGE 7
1 CONNECTIONS • Make sure that all of the components are turned off before making connections. Control cable _1_ To the CONTROL IN jack of the Pioneer component bearing the _] mark. Stereo amplifier I?ooO OUT CD player Red ..... Cassette deck v v _ Red Power cord 1_ ...................... , CD-DECK SYNCHROcable (Suppliedwith the cassette deck) To a household AC wall outlet.
PAGE 8
NAMES AND FUNCTIONS OF PARTS FRONT PANEL ) [_ indicates the page where the control is explained. When the front panel is closed. t I-. POWER STANDBY/ON When the front panel i< open. REMOTE CONTROL UNIT switch Remote sensor Receives the signal from the remote control unit. ADLC button TIME button _3_--------_4_ (_ MODE button CLEAR button_ Display window Track/Manual ------rg) _5)------- search buttons [_ (_<_
PAGE 9
I BEFOREOPERATINGTHE PLAYER I Insert discs into the Rack (only 12-cm discs) I I Insert desired discs into the Racks (1 - 4). Up to 25 discs may be inserted into each rack, and a total of 100 discs can be inserted into the player. The disc grooves are numbered of the rack.
PAGE 10
I BASICOPERATION 2 To play a compact disc UTurn on the power of the player. []Insert discs into the Rack, and close the rack i I wlmlmlw ..... [ and the front panel. • Insert discs to be played into the Racks beforehand. (Refer to "BEFORE OPERATING THE PLAYER" on page 9.) I oo,:z=_J[] O0 Press • • 3 • [] POWER z; POWE R ir- l r, D STANDBY/ON i NOTES: Last disc memory When • is pressed, or the power is turned off, the player memorizes the disc on which playback was stopped.
PAGE 11
BASICOPERATION 1 Changing discs during playback Selecting the playing This unit lets you change up to 75 discs without interrupting playback, but please be aware of the following points. • Do not press the Rack EJECT (A) button in the following situations. 1. When one of the discs in that Rack is playing back. 2. If less than ten seconds has elapsed since the end of disc search or playback. You can determine • which mode ] MODE MODE O Racks cannot be opened from the following two displays.
PAGE 12
I:IA_IL;UPI:HAi ION Direct search - To search for a particular disc or I track (with remote control Track I unit) search - To search for a particular track I in playback or pause mode in playbackor stop mode [Example] To search for track No. 5 on disc No. 37: 3 7 DISC 5 O O NOTE: tf the DISC SET button or the TRACK SET button is not pressed in 5 seconds after the digit buttons are pressed, the display returns to the previous mode.
PAGE 13
VARIOUS OPERATIONS I To play only the desired discs (CUSTOM playback) I All discs (1 - 100) can be divided into 3 CUSTOM modes as your preference. Discs can be selected and stored in memory by music type or artists, etc. Example: enter disc No. 3 and No. 12 into CUSTOM II. [] In the stop mode, press the MODE button so that the CUSTOM II indicator lights. If some disc number appears, press CLEAR on the front panel. Ii Igl Select MODE O disc No.
PAGE 14
VARIOUSOPERATIONS • To repeat playback (repeat play) NOTE: REPEAT D During random playback, with the MODE button. Each time the REPEAT button on the remote control unit is pressed, the repeat mode changes circularly. (one track repeat --* ALL repeat --_ OFF) To repeatedly play the displayed track, press REPEAT on the remote control unit so that the REPEAT • 1 indicator lights. REPEAT can be pressed in any playback mode (normal, random, or program).
PAGE 15
L TO PLAY ONLYDESIRED TRACKS/DISCS Program playback - To program tracks/discs in desired order 2 nPress n Select the disc number which contains the track to be programmed with the digit buttons, and then press the DISC SET button. PGM To program entire discs, enter the desired disc numbers with the digit buttons and DISC SET, and then go to step 4. Make sure that the player is in stop mode for Disc programming. • When the DISC SET button is pressed, "AL" (all tracks) appears on the display.
PAGE 16
TOPLAYONLY DESIREDTRACKS/DISCS I I To reserve the program To clear all of the program cancel Press the PGM button during normal playback. The unit enters program mode and you can program while the song is playing back.Program play starts when either the current track finishes playback or • is pressed. Pressing • when the program indicator is lit also starts program playback.
PAGE 17
[TROUBLESHOOTNHG Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
PAGE 18
SPECIFICATIONS 1. General Type ........................................... Compact disc digital audio system Power requirements ............................................... AC 120 V, 60 Hz Power consumption ................................................................. 12 W Operating temperature ................................................ +5°C - +35°C (+4!OF - +95OF) Weight ................................................................ 11.0 kg (24 Ib 4 oz) External dimensions ..................
PAGE 19
NO. 1 1 ~ 50 INDEX CARD 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 Copy or cut off these index cards, and fill in the titles of the discs in order inserted in the player. It is useful to search for the desired discs if these cards are inserted in the first or last page of the supplied CD liner notes file. NO. 2 51 ~ 100 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 ...........................................................
PAGE 20
I U PLAY A UUMPACi Turn on the power. __ DIS(; 2 Insert discs into the Rack, and close the rack and the front panel. POWER I_ STANDBY/ON Press I--. I.. IP. [ w: ,w'ha rd'abe' s'd" j SELECTINGTHE PLAYING MODE L Press MODE. _ Dr MODE 0 MODE DIRECT SEARCH 1 Select the disc number with the digit buttons. 2 Press DISC SET. [---SET _L2J 3 DISC 4 Press TRACK SET. Select the track number with the digit buttons.