Owner's Manual

( Connecting the System)
( Installation
)
Precautions before
connecting the system
A CAUTION
- Do not route wires where they will be
exposed to high temperatures.
If the
insulation heats up, wires may become
damaged, resulting
in a short circuit or
malfunction and permanent damage to
the product.
• When disconnecting a connector, pull the
connector itself.
Do not pull the lead, as
you may pull it out of the connector. ~
Connection diagram
The navigation unit
30 cm
(12 in.)
i
l
Vehicle Antenna This product
En
Precautions before
i nsta lIation
• Do not install this product in places where
it may become subject to high tempera-
tures or humidity, such as:
- Places close to a heater, vent or air con-
ditioner.
- Places exposed to direct sunlight, such
as on top of the dashboard.
- Places
that may be splashed by rain, for
example close to the door.
• Make sure to connect this product to the
navigation system after the system
is
tu rned off. (ACC OFF)
• Thoroughly wipe off the surface before af-
fixing the adhesive tape.
• Use separately sold adhesive tapes to
se-
cure this product so that it does not move.
It
is extremely dangerous if cords are ex-
posed on the floor as they may become en-
tangled with the brake pedal etc. Hide
cords
so that they do not get in the way
when you are driving.
To guard against
electromagnetic interference
In order to prevent interference, set the follow-
ing items as far as possible from this naviga-
tion system, other cables or leads:
• FM, AM antenna and its lead
•
GPS antenna and its lead
In addition you should lay or route each anten-
na lead as far as possible from other antenna
leads.
Do not bind them together, lay or route
them together,
or cross them. Such electro-
magnetic noise will increase the potential for
errors in the location display.